2m corner profile kit for plasterboard with satin finish and 2 caps

2-meter aluminum corner profile kit for flush-mounting into plasterboard, with satin finish cover and end caps. The corner aluminum profile is used for proper heat dissipation of LED strips. How can I use the corner aluminum profile for flush-mounting into plasterboard? The flat aluminum profile is used for proper heat dissipation of LED strips, which will extend the life of the LED strip. The steps for installing the flat profile are: 1- Install the profile by screwing it to the plasterboard in a corner of your room. 2- Smooth the profile flush. 3- Glue the LED strip inside the flat profile if there is no cover. 4- Make sure it is properly glued, including the beginning and end. If it doesn't adhere perfectly, apply a drop of glue to the back of the strip. 5- Pull the cable out of the perforated cap. 6- Close with the satin cover. 7- Connect your 24-volt LED strip to the power supply and your LED strip with profile is ready! Where can I install the LED strip with the concealed corner aluminum profile including the satin cover? Its ideal application is to create blades of light in the corners of modern spaces such as residential or office spaces. The profile is screwed to the plasterboard and then smoothed flush, so only the light beam protected by the satin cover will be visible. A solution for greater design and extraordinary linearity. Choosing the right LED strip will give you surprising results. It helps protect against dust and external agents, thus achieving a better aesthetic result for greater cleanliness. The kit includes: 2 meters of concealed flat anodized aluminum profile, 2 meters of satin cover, and 2 end caps. Our corner profile is suitable for supporting an LED strip with a maximum power of 28 watts/meter. LED strip not included. Minimum purchase quantity: 2 bars. MAXIMUM POWER SUPPORTED: 28 watts/meter PROFILE COLOR: Satin Aluminum DIMENSIONS: Overall width 50.12 mm Height 13.1 mm Internal width 9.5 mm NOTES: IP20