Microwave and twilight presence sensor for UFO 100W and 150W Alcapower - Detection distance 12m

This product is a microwave sensor that can be installed on the AlcaPower 930233 UFO100E and 930234 UFO150H projectors. The functions of this device are: presence sensor, twilight sensor and dimmer. The 930233 UFO100E and 930234 UFO150H projectors have the sensor connection installed in the center of the reflector. To install the sensor: • Unscrew the closing cap of the connection connector located in the center of the UFO projector. • Insert the sensor's jack connector into the connection connector. • Screw the sensor to the connection connector. Without the use of the UFO presence sensor remote control, supplied separately as an optional accessory, the sensor cannot be adjusted and will only work with the following factory settings: • Detection distance: 100%. • Stand-by interval: 0s (disabled). • Twilight sensor: disabled. Operation: • When the sensor detects motion and the ambient light is below the twilight threshold, or the twilight function is disabled, the projector turns on at the light intensity set by the dimmer function (10%~100%) for a time equal to the set on-time interval. • After the on-time interval has elapsed, if the sensor does not detect motion, it enters standby for the set standby time interval and the projector lights up at the intensity set for the standby interval (10% or 30%). Once the standby interval has elapsed, the projector turns off. For more information, please consult the technical data sheet.